|
The microscope FERTILCONTROL Light has 5 elements: the cap, the principal body, the lighting system and the optical system (two parts, includes a glass and the lens).
|
|
|
1- For their use, remove the cap, leaving visible the principal body of the microscope and you can to see the optical system (the black) at the top of the main body.
|
|
2- Focus the microscope until seeing the simbol while pressing and holding the switch. This step will be done in the first step.
|
|
3-
Remove the optical system of the body. The optical system is removed under pressure, Do not unscrew it and remove the seal.
|
 |
4- Place a drop of saliva on the surface of the crystal. The drop of saliva to be a thin layer covering the entire glass. Remove carefully with your finger any bubbles that form when depositing saliva, being careful not to drag and waiting until the saliva is completely dry (about 20-25 minutes).
|
|
5-
When the saliva is completely dry, place again the opticall system on its base.
|
|
6-
Press the switch that is located at the base of the body to turn on the light. At the same time, approaching the sample to observe the ferns or the points. To focus, rotate the lens while bringing it close to the eye.
|
|
7- If you look at the sample of saliva you still moving back to make the optical system and wait longer to dry completely.
|
We can see if we fertile or infertile period.
|
|
|
Image in infertile period |
Image in low fertile period |
Image in fertile period |
For added security, it should repeat the test. Each woman has her own ovulation cycle, so it is appropriate to conduct the test FERTILCONTROL Light daily, so familiar with your ovulation cycle and to observe any changes. Remember that test a reusable ovulation, so it's a very economical and effective.
You can consult our FAQ section.
|
